Available as three or single color units, using high brightness LEDs and advanced micro-electronics to provide a range of pre-programmed and user field-selectable operating modes with on-board switches to enable different maximum light output levels to be set and to enable control which quadrants of light are active Quadrant Control: There may be situations where an operator requires that the beacon is only visible from certain directions (for example, to avoid dazzling pilots or causing a distraction). Usually this would require the operator to fit screening or similar but with the FEC Programmable Location & Identification Beacon this is simply achieved by disabling the relevant array(s) by means of simple switches on the main circuit board. To disable a particular array simply slide the switch to ON (Disable) using the tip of a ball point pen or similar tool. The relevant array(s) will remain permanently disabled in all programming modes until the switch(es) are turned off again. As shipped, all of the arrays are enabled (all Array Disable switches – Off) giving the full 360o pattern as shown 360 Quadrant 4:4 Arrays opposite.

Electrical Characteristics: Operating voltage: 80-205 VAC Input Average power consumption: Less than 90 watts Protection LED Lifetime (projected): >50,000 hours Relay contact output for alarm monitoring LED

Color Characteristics Standard: White: 6000oK/6500oK ‘Cool White’ Green: 528nm Yellow: 590nm

Options: Red 625nm; Red-Orange 617nm; Hyper Red 656nm or Deep Blue 455nm

Physical Characteristics: 8 inches tall 7.063" Bolt Circle Degree of protection: IP66 Operating temperature: -25oC to +50oC Storage temperature: -25oC to +80oC

Level Setting Switches: Maximum brightness to be set to 4 levels:- 100% of Maximum Level (Factory Set Default) 60% of Maximum Level 30% of Maximum Level 10% of Maximum Level