Programmable LED Three Color Locating Beacon / Single Identification Beacon
$3,950.00 SKU: HP2040
- Beacon comes programmed as Three Color Heliport Locating Beacon
- Includes software to program other options, including US Military, ICAO, Morse Code and others
- Quadrant Control available to provide restricted directional visibility
- Pre-wired for quick, easy installation on any mounting surface
- LEDs provide high brightness for long range visibility
Available as three or single color units, using high brightness LEDs and advanced micro-electronics to provide a range of pre-programmed and user field-selectable operating modes with on-board switches to enable different maximum light output levels to be set and to enable control which quadrants of light are active Quadrant Control: There may be situations where an operator requires that the beacon is only visible from certain directions (for example, to avoid dazzling pilots or causing a distraction). Usually this would require the operator to fit screening or similar but with the FEC Programmable Location & Identification Beacon this is simply achieved by disabling the relevant array(s) by means of simple switches on the main circuit board. To disable a particular array simply slide the switch to ON (Disable) using the tip of a ball point pen or similar tool. The relevant array(s) will remain permanently disabled in all programming modes until the switch(es) are turned off again. As shipped, all of the arrays are enabled (all Array Disable switches – Off) giving the full 360o pattern as shown 360 Quadrant 4:4 Arrays opposite.