The new design of this Inset perimeter light is the latest addition to the FEC Heliports line of high quality LED lights. Perimeter lights are one of the most important safety features on your heliport. They are used to mark and illuminate the FATO and TLOF as well as to help the pilot locate the pad and safely land during night operations and inclement weather conditions. The inset light is used in place of an elevated heliport perimeter light at locations where the lights are frequently knocked down by aircraft and or maintenance vehicles. These lights are strong enough to drive over without damaging the light.

Certifications & Compliances

• ETL Listed to UL2108
• ETL Listed to UL1598 at -40⁰ c to +55⁰c
• ETL Listed to CSA C22.2 NO. 250.0-08
• FAA EB#87, L-860HR & HS
• FAA AC 150/5390-2 (Latest Rev.), Heliports Design Guide
• ICAO Annex 14, Volume II
• UK CAP 437
• UK CAP 1264

Electrical characteristics:

Operating Voltage:	120/277V 50/60Hz input 12/24 VDC Output via FEC PLC Controller
Operating Power:	6 Watts @ 0.350ma
Operating Temperature:	-40⁰c to +55⁰c
Operating Lifespan:	LED’s Rated at 50,000+ hours
Light Source:	1x Osram Visible LED 3x Osram IR Diodes

Physical characteristics:

Dimensions
Height Above Surface:	1.0" (25.4mm)
Body Diameter:	6 1/2" (165.1mm) to 4 3/4" (120.65mm)
Mounting Flange Diameter:	10" (254mm)
Mounting Pattern:	7 3/4" (196.85mm) BHC, 8 equally spaced 1/4" (6.35mm) holes, 82⁰ C-Sink
Materials
Flange Material:	6061-T6, QQ-A-200/8
Housing Material:	356-T6 Aluminum Alloy
Lens:	Tempered Borosilicate
Hardware:	18-8 Stainless Steel
Finish:	Hard Anodize per MIL-A-8625 Type II, Class 1

Light Base
Dimensions
Height:	6 5/8" (168.27mm)
Outside Diameter:	11" (279.4mm)
Inside Diameter:	8 1/2" (215.9mm)
Light Base Material:	356-T6 Aluminum Alloy

All machining on the aluminum casting is done in house by FEC Heliports

Shipping weight w/o light base: 4lbs.
Shipping weight w/ light base: 10lbs.